JK White Cement Works, Gotan

Our pioneering foray into white cement in 1984 created a new chapter in the history of JK Cement and the JK White Cement Plant is an integral part of the same.

We were the first White Cement facility in India, which was limestone based, and manufactured Cement through the dry process. The White Cement plant was commissioned at Gotan, Rajasthan with an initial production capacity of 50,000 tons.

JK White, Katni

The Company has set up a white cement based Wall Putty manufacturing unit at Katni, M.P. with an initial capacity of 2 Lac tonnes per annum. Commercial despatches commenced on 26 th May, 2016.

The Company plans to set up, in phases a capacity of 6 Lakh tonnes. With this, the Company has achieved a capacity of 7 Lac tonnes for Wall Putty manufacturing in India.

Manufacturing Process

At JK White Cement Works, Gotan we use technical expertise from F.L. Smidth & Co. from Denmark and state-of-the-art technology with continuous on-line quality control by micro processors and X-rays to ensure that only the purest White Cement is produced. We manufacture White Portland Cement through these 5 significant stages – crushing, raw meal grinding, clinkerisation, cement grinding and packing for dispatch.

  • At raw mill, crushed limestone, clays and feldspar of desired chemical compositions are fed through electronic weigh feeders.
  • Clinkerisation is the heart of cement manufacturing process, where the raw material is fed to pre-heater at controlled rate through electronic weigh feeder. The feed enters the kiln through cyclones and fuel is fired at the kiln outlet end.
  • Clinker and gypsum are fed to the cement mills through electronic weigh feeders at controlled rate and ground in ball mills. The classifier (high efficiency separator) controls the fineness of white cement. The finished product of desired chemical composition and physical properties is transported to Cement Silos for storage.
  • White cement is drawn from cement silos, for packing in bags by electronic rotary packer and in small pouches by Fill, Form and Seal machines.

Quality Control

At JK White Cement, quality is not just a product centric vision but a business practice. JK White Cement upholds international quality standards. We have always been at the forefront when it comes to adopting newer and sustainable technologies that are also aimed at continual improvement of quality. Our unit at Gotan has the certification of Quality, Energy, Environmental, Occupational Health & Safety Management System and Social Accountability International that requires a company to work towards continual improvement, choose the best technological options, opt for preventive measures rather than symptomatic treatments, conserve natural resources and requires committed leadership with total employee involvement and commitment to society. Our wall putty unit in Katni follows the Singapore quality standard, HDBS. To ensure that the final product meets the quality standards of the industry, it goes through an extensive testing process. It is tested for whiteness, residue, workability, tensile strength, water demand, water absorption, viscosity, pot life, water retentivity, compressive strength, bulk density etc. The unit is in the process of getting Social Accountability SA: 8000 certification.


At JK Cement, our quality parameters have been verified by various certification bodies. All our units are certified with Quality Management System and Environmental Management System as per ISO 9001 and 14001. The Certification Agency is Lloyds Register Quality Assurance Limited. Besides the above, our White Cement plant is also certified for OHSAS 18001 and SA8000. JK White Cement carries the CE Mark (Mark of European Conformity as per European Construction Products Directive)